Encrypted login | home

Program Information

Investigation of Different Bleaching Wavelengths On the Absorbed-Dose Sensitivity of NanoDot OSLDs Exposed to 6 MV X-Ray Beams


A Omotayo

A Omotayo1*, J Cygler2, G Sawakuchi1, (1) Carleton University, Ottawa, ON. (2) The Ottawa Hospital Regional Cancer Center, Ottawa, ON.

SU-E-T-90 Sunday 3:00:00 PM - 6:00:00 PM Room: Exhibit Hall

Purpose: To determine the effect of different bleaching wavelengths on the luminescence response of Al2O3:C optically stimulated luminescence detectors (OSLDs) exposed to accumulated doses of 6 MV photon beams.

Methods: OSLDs of the nanoDot type were used and readout with a microStar InLight reader. To determine the effect of different bleaching wavelengths on the luminescence response of nanoDot OSLDs, we optically reset (bleached) the OSLDs with 26 W fluorescent lamps in two modes: (i) directly under the lamps for 10, 120 and 600 min; and (ii) with a long pass filter for 55, 600 and 2400 min. The long pass filter blocks wavelengths below 495 nm, hence the longer bleaching duration to attain equivalent OSL signals as bleaching directly under the lamps. Changes in the sensitivity of the nanoDot OSLDs were determined for an irradiation-readout-bleaching-readout cycle, after irradiations with 1 and 10 Gy dose fractions.

Results: The nanoDot OSLDs presented a linear response to dose up to 2 Gy and supra-linear response afterwards. They produced different OSL signal loss and fading behaviors for doses of 1 and 10 Gy. OSLDs bleached for 120 min and 600 min without and with the filter in 1 Gy fractions, did not exhibit any significant change in sensitivity over an accumulated dose of 7 Gy. The OSLDs exposed with 10 Gy fractions exhibited a small under-response when bleached with filter, and an over-response when bleached directly without filter.

Conclusions: The nanoDot OSLDs may be reused without a significant sensitivity change for accumulated doses below 7 Gy. However, for accumulated doses beyond 10 Gy, nanoDot OSLDs show significant sensitivity change and hence, need to be recalibrated for reuse. We also concluded that the light spectrum used to reset the OSLDs has an influence on the sensitivity of the detectors.

Contact Email