Encrypted login | home

Program Information

Incorporating Skin Flash Into VMAT WBI: Impacts On Surface Dosimetry

no image available
A Bejarano Buele

A Bejarano Buele*, S Tanny , G Warrell , E Parsai , University of Toledo Medical Center, Toledo, OH

Presentations

SU-E-T-489 (Sunday, July 12, 2015) 3:00 PM - 6:00 PM Room: Exhibit Hall


Purpose:
Increased use of inverse planning limits the amount of skin flash in whole breast irradiation (WBI). Strategies to incorporate flash into inverse-planned treatments involve overriding air to the density of water or tissue. This introduces uncertainties to the superficial dose distribution, potentially degrading the coverage at the skin-bolus interface. We investigate the accuracy of various commonly used bolus materials to incorporate flash in VMAT WBI plans while minimizing the perturbation near the skin.

Methods:
We obtained a CT-simulation of an anthropomorphic phantom with a breast attachment. Three VMAT plans were created with different boluses: 1 cm of 1 g/cm³ bolus (Superflab), 1 cm of 0.65 g/cm³ bolus (wet towels), and 1 cm of g/cm³ bolus with 2 dose levels accounting for the difference between bolus and tissue density. The PTV was extended into the bolus, outside the patient body contour to incorporate flash. OSLDs were used to obtain surface doses at the medial, lateral and tip sites of the breast. Each plan was irradiated four times using CBCT for positioning and dosimeter localization.

Results:
The average thickness of the wet-towel bolus on delivery was 8 mm with a CBCT-measured density of 0.6 g/cm³. OSLD measurements demonstrated good agreement with predicted doses from Pinnacle. Average deviations were -5.7%, -2.5%, and -2.6% for plans 1, 2, and 3, respectively. OSLDs placed at the medial and lateral portions of the breast showed the largest average deviations. The maximum recorded deviation from planned values was -8.6%. The largest dose fluctuations occurred near areas where the bolus failed to properly conform to the breast contour.

Conclusion:
Use of wet-towel bolus improved dose delivery accuracy compared to standard Superflab bolus. Areas of poor bolus conformity adversely affected dose delivery. We recommend the use of wet-towel bolus over Superflab bolus for VMAT WBI.


Contact Email: